-40%
PIETRO FIORENTINI F31154 OPD-7-BY VL CAP, 1-1/2
PIETRO FIORENTINI F31154 OPD-7-BY VL CAP, 1-1/2

PIETRO FIORENTINI F31154 OPD-7-BY VL CAP, 1-1/2" Governor Gas Pressure Regulator

$ 448.79

Availability: 100 in stock
  • UPC: Does not apply
  • Brand: PIETRO FIORENTINI
  • Item Diameter: 1.5"
  • Type: Gas Valve
  • All returns accepted: ReturnsNotAccepted
  • MPN: 31154-OPD
  • Condition: New
  • Model: 31154-OPD
  • Country/Region of Manufacture: United States

    Description

    Pietro Fiorentini governor series high capacity 31154-OPD, 1-1/2" NPT over pressure protection line pressure gas regulator with vent limiter and filter for 10 PSIG piping systems.
    ANSI Z21.80/CSA 6.22 certified
    10 PSIG Inlet pressure
    6-14"WC Outlet Range
    Includes inlet filter
    Positive dead-end lockup regulator
    Install indoor horizontal or vertical* with vent limiter installed
    *Requires vent adaptor for indoor vertical installation with vent limiter
    Includes Green vent protector for outdoor installation
    Natural gas or LP (Propane) gas
    Made in
    USA
    The Pietro Fiorentini F31154 OPD-7-BY VL CAP 5 PSIG Governor 1-1/2" NPT with Filter Line Pressure Regulators Over Pressure Device (OPD) Model comply with and are certified to CSA 6.22a-2005 and ANSI Z21.80a-2005 for 5 PSIG inlet applications. The Governor OPD design incorporates an integral vent limiter in the regulator. To ensure the installation complies with CSA 6.22a-2005 and ANSI Z21.80a-2005, the vent cap should be left in place and at no time should any restriction or plug be installed in the vent cap of the regulator.
    When using an external vent limiter, the flat top of the vent limiter must always be facing up, with the threads facing down, so it operates properly. The Governor OPD operates as a monitor and a worker regulator. The first regulator is the monitor and the second regulator is the worker. If the worker regulator fails, the monitor regulator takes over at a safe pressure, normally 70% higher than the worker pressure. For example, if the worker is set at 7" w.c., the monitor would be set at 7" x 1.7 which = 12" w.c.. This keeps the operating set point below the CSA 2 PSIG limit.
    The inlet pressure range is 7" w.c. to 5 PSIG. This regulator comes with a black outlet spring, with a pressure range of 6" w.c. to 14" w.c..
    The 5 PSIG Governor Line Pressure Over Pressure Device (OPD) Model Regulators range from 1/2" to 4" NPT sizes and are suitable for use with Natural Gas, LPG, and other non-corrosive, clean gas.